- 3 layer polypropylene top fabric keeps out rain and snow while single layer polypropylene side fabric venting inside vapor out
- Multiple zippered panels for easy access to the front, back & sides
- Air vents reduce wind stress and vent inside moisture out
- New methods of installing RV cover save your time
-
2 years warranty.
Water repellency
Rugged water repellent polypropylene fabric resists mold and mildew
Breathable
Breathable fabric reduce inside moisture
Patented
Easy setup feature with Leader Accessories Patented DESIGN
Easy Setup
Easy setup with assist poles provide convenience
This RV cover is designed for a new installing method. It can save lots of your time.
1.Adjustable front & rear tension panels provide a custom-like fit
2.Multiple zippered panels for easy access to the front, back & sides
3.Reflective panels for safe parking at night
4.Air vents reduce wind lofting and inside moisture
5.Reinforced corner patches resist tears and snags
6.Elasticized bottom corners for fast and easy fitting
7.Unique Rope tie down aid
8.Full cut to allow room for ladders,air conditioners etc.
9.Easy installation,easy removal
10.Free Storage bag and ladder cap included
11. With a pair of assist steel pole to lift and pull your cover
Note:Please measure your RV to ensure a proper fitting size.Overall length includes bumper ,but not hitch. Pls add 1 foot to total length if you have a roof mounted AC unit. Measurement including spare tire if mounted to the back of your camper.
Step 1
Unfold the steel poles. Locate the 2 pockets on top side panel near the end of the cover. 2 people stick the steel poles into each pocket and lift it up at the same time.
Step 2
Both operators stand by the front of RV, raise the cover up over the roof of RV, pull the cover carefully from the front to the end of RV until the cover is on the correct position.
Step 3
Release the back panel from the top of RV. Zip all the panels on your RV cover then pull the elasticized corners down over both bumpers of the RV.
Step 4
Attach all of the male strap/buckles to the corresponding female
strap/buckles. Adjust all of the tension straps of your cover for a snug fit. Don't over tighten.